23>
24>
Cleaning the Sponge
Q&A
What should I do when my skin turns redness after using this product?
It's normal for the skin have redness due to temporary irritation,don't worry
and we have tested 1000+ users, 98% of users' skin redness is gone after
0.5 ~24 hours.
Blackheads are not sucked out, what should I do?
We recommend to use warm towel or steam for 10-15 min to open the pores
before using ,then use it with the blackhead export liquid for a better effect .
When is the best time to use？
Best before going to bed to use it,your skin will recover while you sleep.
What should I pay attention to when using the product?
As it has a strong suction force, do not press the suction port strongly against
your skin ,don't keep it in one place more than 3 seconds. Short and fast shots
and repel blackheads horizontally,do not suck the blackhead at a 90 degree
angle, it could damage the skin.
Can I change the suction strength?
We have 3 suction levels,For first time, we recommend use the level 1 to allow
your nose to get used to the intensity,then you can adjust the suction level
according yourself.
Will the pores become larger after use?
After using this product, wash your face with cold water and use ice towel or
skin care products(shrink mask) to shrink pores.
what should I do if I get a little red?
It is normal as it will cause some irritation to your skin when you use it. Please
put wet towel with cold water on the face to massage and relieve the feeling
of stimulation after removing the blackhead.
Q:
A:
Q:
A:
Q:
A:
Q:
A:
Q:
A:
Q:
A:
Q:
A:
A sponge to catch the sucked dirt is set in the suction port of this product.
If you feel the suction or power is reduced, the sponge becomes dirty and clogged.
In this case, follow the steps below to clean the sponge.
Rotate the suction to remove it.
Remove the sponge.
Clean the dirty sponge with water and a mild detergent and let it dry.
Place a clean sponge on the mouthpiece.
Align the hole on the suction with the point on the main body.
Press down the suction and install it on the main unit.
Disassemble the tip and sponge:
Install the suction and sponge:
Align
