130
2017/09 Rev. 0.0
OptiFresh (Bean) Touch
12.2.3 Programme a new token
The token shown opposite is already programmed in
the coin changer [Token A].
For programming a new token {[B] see detailed token
teach instructions in the NRI technical documentation.
Attention; switch the machine OFF/ON twice after a
new token has been programmed.
12.2.4
Coin channel cleaning
Only the changer’s coin path, flight deck and sorter
cover must be cleaned from time to time.
ATTENTION
● The cloth must not be so wet that liquid enters the
system or the circuit board could be damaged.
● Do not use any solvents and/or abrasive cleaning
agents that could attack the plastic.
● We advice to use a water free Surface cleaner (e.g.
Surface 95) to remove the coin channel from grease,
and dirt.
1. Turn power OFF.
2. Unlatch sorter cover (blue latch on the right of the
display) and swing it open [A & B].
3. Open flight deck at the insert funnel and hold it open
[C].
4. Remove any debris. Dust off any accumulation with
a small brush or compressed air.
5. Clean the complete coin path, front and back, with a
slightly wet cloth.
6. Allow to dry.
7. Close flight deck and latch sorter cover.
8. Turn power ON.
12.2.5 Fault analysis
For a detailed diagnosis of the fault, see the NRI
technical documentation.
A
C
B
