OPERATION
HOLDING THE WORKPIECE
Hold the workpiece directly UNDERNEATH the disc.
Apply the workpiece to the BOTTOM of the SPINNING
disc GENTLY and with EVEN pressure.
STAY WITHIN THE SEE-THRU AREA OF THE DISC!
DO NOT WORK
OR
SLIDE
OFF THE EDGE OF THE DISC!
The tool’s sharp edge or tip can trim the outer edge of
disc causing damage to the disc & kick back of the tool.
When possible, work on the 3 to 6 “o-clock“ portion
of the disc. This will ensure that any dust or sparks
are projected toward the vacuum port, away from you.
FINDING THE CORRECT ANGLE
!
REMEMBER!
ROTATION OF THE DISC
IS COUNTER-CLOCKWISE
DO NOT POINT ANY EDGE OR TIP TO THE
OPPOSITE OF DIRECTION OF ROTATION!
STEP 1:
Lightly make contact
with the “back” of the
tool’s edge to the disc.
STEP 2:
Lift the entire width of
the edge flat against
the disc. Hold in place.
STEP 3:
When the desired
result is achieved.
DROP TOOL DOWN.
To maintain the angle of your flat tools. Follow these steps.
10
