IT
GB
DE
FR
ES
C
1
39
61
6
4
0
1
.f
m
- 13 -
English
To carry out this operation, proceed as follows.
1 - Turn on the drain tap (A) to empty the pan, and
leave it open.
2 - Undo the locking screw (B).
3 - Pull off the cone (C).
4 - Check the seals for wear and replace them if
necessary.
5 - Clean the cone (C) and its seat.
6 - Coat the cone (C) with edible fat , fit it in its seat
and turn it a few times.
7 - Pull off the cone (C) to remove the excess
grease.
8 - Replace the cone (C) and tighten the screw (B).
The appliance has been tested before being put
into service.
The information provided below is intended to as-
sist in the identification and correction of any anom-
alies and malfunctions which might occur during
use.
The user can solve some of these problems
himself, but for others specific technical
knowledge or skill is required, and so they must
only be carried out by qualified staff with recognised
experience acquired in the specific sector of opera-
tion.
GREASING THE DRAIN TAP
FAULT
6
TROUBLESHOOTING
Faults
Causes
Remedies
The heating elements do not
come on
Electrical connection not made
correctly
Check the connection of the
electrical wires
Safety thermostat tripped
Carry out the appliance reset
(see page 10)
Switch faulty
Replace the switch
The pressure gauge has detected
an abnormal pressure (> 0,5 bar)
inside the jacket
Pressure control valve fouled or
damaged
Clean the pressure control valve
and call the after-sales service if
necessary
The safety thermostat is tripped
too often
The water level in the jacket is not
correct
Restore the water level in the
jacket; if necessary call the
aftersales service
IDM-39615401000.tif
B
C
A
C
