IF THE ALARM DOES NOT SOUND
• Avoid contact with crib while Sensor Pad is in operation, or leave the room in case
of a wooden floor.
• Place crib near a supporting wall.
• Adjust Sensor Pad sensitivity level.
5.3 - CHANGING THE MOVEMENT AND SOUND MONITORING FUNCTIONS
1)
Press briefly the
MENU
button once and
the flashing icons will appear.
2)
Use the
UP
and
DOWN
Arrows to select
your preferred detection mode.
3)
Press the
SELECT
button to confirm
your choice.
4)
Press the
MENU
to view the next option,
or
EXIT
if you wish to stop programming.
1)
Move your hand lightly on the mattress.
Pendulum icon will appear
on Parent Unit indicator bar.
It will move as you move your
hand and trigger a ‘TIC’ sound.
2)
Remove your hand from the mattress.
After 15 seconds you will hear a
‘TIC’ pre-alarm sound, and 5 seconds
later the Movement Alarm will trigger.
3)
Repeat by moving your hand lightly
in all four corners of the mattress.
Ensure the Nursery Unit Movement
Indicator is still flashing.
1
2
TO SET DETECTION MODE:
TO TEST THE SENSOR PAD:
MOVEMENT OR “TIC” MODE NEED TO BE ACTIVATED:
MOVEMENT ALARM
• If NO movement is detected after 15 seconds you will hear a single ‘TIC’ pre-alarm sound from
the Nursery Unit.
• If after a further 5 seconds there is still NO movement detected both the Parent Unit and Nursery
Unit speakers will emit loud warning sound.
• Nursery Unit icon flashes on the Parent Unit
• Green light on the Nursery Unit will turn off to indicate NO movement is being detected.
3
2
1
NOTE:
If you press the
MENU
button for too long
the unit will go in to connection mode and the
Out-of-Range indicator will start flashing. If this
happens, wait 20 seconds and then press
the
MENU
to start again.
Movement Only
Sound Only
‘TIC’, Sound & Movement
Sound & Movement
‘TIC’ & Movement
107
E
N
04mf8_User_guide_AC403_12001_BELGIUM.indd 107
2015-10-05 4:31 PM
