Sensor Pad
1) Remove the mattress from the cot.
2) Place the Sensor Pad - Angelcare
®
logo side
up - in the center of the mattress. It should be
centered on the hardboard if your cot requires a
hardboard support.
3) Replace the mattress.
IMPORTANT
• Ensure the Sensor Pad is in the center of the cot – printed or Logo side up – on top of the hardboard. Check
the position is central before each use.
• BEFORE FIRST TIME USE: Test that the unit is ready for use – refer to the Full User Manual to check if
installation is correct.
STEP 3 - TURNING ON YOUR MONITOR
Press and hold the Nursery Unit
ON/OFF button for
2 seconds until the Nursery Unit
Indicator flashes slowly in green.
The Nursery Unit will emit a
sound and flash blue to
confirm pairing with the
Sensor Pad
NOTE:
If the green light does not appear but the red
light is flashing; or if there are false alarms,
adjust the sensitivity level (Step 4.3).
STEP 4 - GETTING TO KNOW YOUR MONITOR
4.1 TESTING THE SENSOR PAD:
1
2
3
1) Move your hand lightly on the mattress.
2) Remove your hand from the mattress. After
15 seconds you will hear a pre-alarm sound and
the light will flash red.
3) 5 seconds later the Nursery Unit will emit loud
continuous beeps and the light will flash red
continuously - this is the movement alarm.
MOVEMENT ALARM
• If NO movement is detected after 15 seconds you will hear a
single pre-alarm sound from the Nursery Unit.
• If after a further 5 seconds there is still NO movement
detected, Nursery Unit speakers will emit loud continuous
beeps.
IF THE ALARM DOES NOT SOUND
• Avoid contact with cot while Sensor Pad
is in operation.
• Place cot near a supporting wall.
• Adjust Sensor Pad sensitivity level.
• Turn OFF cot mobile, fans, loud music or anything
else that may cause vibration.
29
E
N
256AC_01_Manuel_AC017_Pabobo_m2.indd 29
2018-05-30 10:30 AM
