Installation Guide
Angel Armor Avail ballistic door panels (Level III) FOR DODGE CHARGER PURSUIT
970 235 2961 [email protected]om angelarmor.com
12
Removing the Vehicle Door Panel
and Speaker
CONTINUED
3
Using the door pry tools, remove the
rubber trim cover in the armrest pocket.
Figure 25. Removing the armrest pocket trim cover.
4
Remove the Phillips screw from the
armrest pocket.
5
Using the door pry tools, remove the
window control panel from the door
panel.
6
Disconnect the wiring harnesses from the
window control panel.
7
Locate the round plastic fastener near
the middle of the inner edge of the door
panel. Use a screwdriver to gently push
in the small round center piece of the
fastener, and then pry out the outer edge
to remove the fastener.
Figure 26. Removing the fastener at the inner edge of the
door panel.
8
Use a Phillips head screwdriver to remove
the screw surrounded by a rubber
bumper on the outer bottom edge of
the door panel.
Figure 27. Removing screw at bottom edge of the door panel.
9
Starting at the lower back corner, pry
the interior vehicle door panel away
from the door to disengage the plastic
snaps. Work your away along the bottom
edge and both sides of the door panel to
disengage the snaps.
Figure 28. Prying the door panel away from the door skin.
