Installation Guide
Angel Armor Avail ballistic door panels (Level III) FOR DODGE CHARGER PURSUIT
970 235 2961 [email protected]om angelarmor.com
10
Installing OEM Hinge Reinforcements
and Check Strap
CONTINUED
8
Place rivets into bracket/door holes (five
on upper bracket, four on lower bracket).
Use the riveting tool to squeeze and
secure the rivets in place.
9
Once the adhesive has cured, replace the
inner door trim.
10
Pre-bend the check strap, and use a
1/2” wrench to remove the top bolt on
the upper door hinge on the vehicle side.
Mount the check strap so the strap is
facing outward before replacing door.
11
Hang the door back on the vehicle,
secure check strap to the door hinge bolt
and replace and tighten hinge nuts while
applying positive upward pressure on the
bottom of the door. This helps prevent
door sag and misalignment during door
installation.
NOTE:
The installed strap helps
prevent over-extension of the vehicle
door. Adjustments to the door hinge
will be made after armor is installed
for proper alignment due to the added
weight of the armor. Nut torqueing will
occur after final adjustment.
12
After the check strap is installed, push
the strap in while slowly closing the door.
This inward motion creates a memory for
the strap, allowing the door to close in
the same manner.
Figure 19. Proper placement of the secured check strap.
13
Reconnect the wires and wire harness
between the door and vehicle.
Preparing for Ballistic Door Panel
Installation
1
Open the front driver-side door and
lower the window glass completely.
2
Turn off the vehicle ignition switch, and
remove the key.
