20
SINGLE ESPRESSO GRINDER
NOTE!
Risk of damage!
The operator cannot adjust the thermal overcurrent circuit-breaker. If
the circuit-breaker has been triggered several mes, a service partner
must be contacted for advice as the motor winding may be damaged.
Adding espresso beans
1. Remove the lid from the bean container
(1)
.
2. Pour whole roasted espresso beans into the bean container from above.
• The
maximum
fi
lling quan ty should be approx. 1 cm below
the edge of the bean container.
• The
minimum
fi
lling quan ty should not fall below approx. 2
cm in order to ensure that there are no dispensing
fl
uctua-
ons.
3. Place the lid back onto the bean container.
4. If necessary, open the bean container by pulling out the sliding valve
(20)
(see
Fig. G
).
Switching on the grinder
1. Ensure that the power plug is inserted into a properly installed earthed
socket.
2. Make sure that the start bu on
(8)
is in posi on 0.
3. Switch on the grinder by moving the On/O
ff
switch
(5)
to posi on “I”.
The grinder is now ready to use.
Summary of Contents for AE 65 V
