SLG I&O Series
10
DO NOT leave the appliance unattended during cleaning. Never let the water level go below the
“Min Level” mark stamped on the tank.
c.
Using the cleaning brush, scrub the inside of the tank to remove the protective coating.
d.
When cleaning is complete turn the appliance off, drain the water into a container suitable for
hot water and dispose of it.
Warning
Wear protective gloves and clothing when cleaning and draining the appliance and when
disposing of water. The water is extremely hot and can cause severe injuries.
e.
When the tank has cooled, rinse thoroughly with cool water. Continue to rinse the tank
until the cleaner has been completely and thoroughly rinsed from the tank.
f.
Using a clean dry cloth, wipe out all of the water. Be very thorough when removing the
water, as any residual water will cause hot shortening/oil to splatter out of the appliance.
Notice
Mild steel tanks must be wiped down/coated thoroughly with shortening/oil to keep the tank
from rusting
4 Filling
the
Tank
Both liquid and solid shortening/oil can be used in this appliance, but liquid is preferred. If solid
shortening/oil is used it is recommended that you melt the shortening/oil before adding it to the appliance.
You can melt solid shortening/oil in the appliance, but you must be very careful not to scorch the
shortening/oil.
4.1 Filling the tank with liquid shortening/oil
To fill the tank with liquid shortening/oil refer to the following procedure.
a.
Ensure that the drain valve is completely closed and that there is no
residual moisture in the tank.
b.
Fill the tank with shortening/oil. You may fill the tank to the “MIN
LEVEL” mark or slightly below the nominal level mark: the
shortening/oil will expand slightly when it heats up, raising the level
slightly.
Summary of Contents for SLG100
Page 19: ...SLG I O Series 19...