Anest Iwata E-M20 Series, Instruction Manual

Page: 60 / 70

- 18 -
Job − 2 Point gun downwards, clean inside of barrel, and blow solvent with air .
Job − 3 Screw lightly new fluid needle packing set with special screwdriver.
（５） Fit fluid needle bar set
Job − 1 Insert fluid needle bar set from rear section of gun and fit fluid needle spring and fluid adj. knob.
Job
−
2 Screw lightly fluid needle packing set with special screwdriver and tighten further by about 30
°
after
screw stops.
（６）
Fit fluid nozzle
Job
−
1 Pull trigger
（
Keep on pulling trigger till job
−
3 is finished
）
Cleaning barrel with its head
pointing upwards can make
dirty
thinner enter air
passage, failing air valve and
fluid needle.
Special driver
New fluid needle packing set
Special driver
Fluid needle set
Bar set
Fluid needle bar set Fluid needle bar spring
Fluid adj. knob