Page 10
Step 6: Setting up your Wearable
1) The Wearable is ready to use. Please make sure someone is
near your Mobile Alert Phone when testing your Wearable.
2) Press the center of the Wearable (this is where the call
button is located) for three seconds.
3) You will feel the click of the Button when you first push it.
Hold the Button down until the green LED turns on (3
seconds) and then RELEASE it. You will see the LED at the top
of the button start to flash. A green LED flash
indicates that you are initiating a call from
your Mobile Alert Phone to the call center.
While the green LED is flashing, you may
cancel the call by pressing and holding the
Button for three seconds. The LED will stop
flashing and the call will be cancelled.
4) A red LED flash indicates that your Wearable is
unable to initiate a call from your Mobile Alert
Phone. Please move closer to your Mobile
Alert Phone and try again.
5) Whenever a call is initiated, the Mobile Alert
Phone
will announce “Dialing Call
Center
”. You may cancel
this call by pressing and holding the call button on the
Wearable for three seconds. The green LED will stop flashing
and the Mobile Alert Phone
will announce “Call Cancelled”.
6) If the call goes through, please tell the Call Center that you
are OK and that this is a test call.
7) Your Wearable is now paired and you have verified that you
are able to start a call to the call center on the Wearable.
8) Your Wearable is water resistant, but it is not waterproof. It
can be splashed, but it should not be submerged.