50
Issue 2 14/07/16
5
Operating Instructions
5.7.1 Water heater display and control buttons
5.7.2 To increase Setpoint temperature
1. Depress and hold ‘Temperature Up’ button until desired
setpoint temperature appears in the display (Fig. 25).
2. ‘Setpoint’ indicator begins flashing in the display after
pressing ‘Temperature Up’ button (Fig. 26).
3. Press ‘SET’ button for new setting to take effect immediately.
‘Setpoint’ will stop flashing. If the “SET” button is not
pressed, the new temperature setting will take effect in
approximately 10 seconds (Fig. 27).
Temperature Setpoint
in Degrees F or Degrees C
Range 70 - Max. °F
Range 21 - Max °C
Shown flashing in display
only when temp is adjusted
Temperature up button
Temperature down button
Set button
Sequence of operation
indicator reads
‘Idle’ or ‘Heating’
Select button’
Status indicator read
‘Operation’ or ‘Service needed’
Fig. 24
Fig. 25
‘Setpoint’
flashes
Fig. 26
‘Setpoint’
flashes
for 10 seconds
Press SET button
for setting to take
effect immediately
Fig. 27
Summary of Contents for ECOflo EC230/600
Page 106: ...106 Issue 2 14 07 16 ...
