Anderson Group
Double Stretcher – Operator’s Manual
33
10
Trouble shooting and repair
The following table describes the most common problems you can run into with your double
stretcher. It also gives you solutions to resolve them. If your problem does not appear in this
table or if you do not manage to resolve it by yourself, communicate with the Anderson service
department (see section Introduction) at the beginning of this manual.
Warning!
Also refer to the operator’s manual of the wrapper
for other troubleshooting and repair solutions.
Table 1 – Troubleshooting
Problem
Possible causes
Solution
The cut and
hold does not
cut the plastic
The plastic film is not set
properly in the cut and hold
system.
Make the adjustments as described in
chapter 6 Adjusting during the wrapping
of the first bale
The blade of the cut and
hold is not sharp enough or
broken.
Change the blade of the plastic cut and
hold.
The button (round valve at
the back of the wrapper) is
in the open position.
Turn the button ¼ turn to close the
plastic cut and hold.
The plastic does
not hold after it
is cut after a
finished bale
The plastic cut and hold is
not adjusted correctly.
Adjust the plastic cut and hold by
following the instructions in section 8.2.
The plastic tears
on the stainless
folding arm of
the double
stretcher
system.
The stainless steel arm of
the double stretcher needs
to be cleaned.
Clean the arm by following the
procedures in section 8.1
The stainless steel arm is
scratched.
Sand the arm by following the
procedures in section 8.1
The folding arm
of the double
stretcher will
not lower.
The valve of the double
stretcher is closed.
Open the valve.
