Anderson 590HS, Operator'S Manual

Page: 15 / 94

13
Adjusting the Plastic Film Cutter
First check the condition of the stainless steel blade (1) in the diagram of (Figure 4.4) and
change it as necessary.
Figure 4.4 Plastic film cutter blade
Additionally, by pushing the plastic in the direction of the blade, the fingers normally push the
rubber stopper to the adjustment bolt in the back. Conversely, a spring provides tension from
the stopper toward the fingers in order to hold onto the end of the plastic for the next bale.
This bolt and this spring can be adjusted as necessary.
Bale Unloading Platform
Figure 4.5 Bale unloading platform D3
This equipment makes it possible to bring the bales to a vertical position and set them down on
the flat side.
1
5
4
2
1
3