Anderson 590HS, Operator'S Manual

Page: 24 / 94

22
6 Troubleshooting: Problems and Solutions
Before calling a technician, examine your machine and consult the table below to find a
solution. Attempt to isolate the problem to find out if it is a hydraulic or electrical problem by
using the manual functions on the hydraulic valve. If you are still not able to solve the problem
yourself, ask for help from the customer service department of your agricultural dealer.
If you think that it an electronic failure, refer to the Computer for single wrapper operator’s
manual.
Problems Possible Causes Solutions
1. Table
alignment
cannot be
performed.
The battery is too weak
Make sure you have 12 V by recharging or changing the
battery.
2. The
turntable does
not turn or
turns slowly.
The hydraulic oil level is
too low. Loss or lack of
oil.
Check for oil leaks and breaks. Retighten or repair as
necessary. Add hydraulic oil to the tank.
Check if you still have 12
V.
Recharge or change the battery.
3. The plastic
film wrapping
is
unsatisfactory.
The plastic film breaks,
develops holes, or tears
during wrapping.
Check if the roll installed was damaged to begin with and
replace it if necessary.
Check if hay or something else is inhibiting or blocking the
plastic film stretcher. Remove the object and clean the film
stretcher. Check if all the rollers are turning freely.
The film is too soft because is has been in the sun for too
long before being used. Install a cooler roll.
The plastic film is not
tight enough on the bale.
Check if the plastic film roll is properly installed.
Check if the parts of the plastic film stretcher are in good
condition and turn freely. Repair as needed.
4. The plastic
film cutter
does not work
well.
The plastic film cutter
clamp does not hold onto
the end of the plastic
film.
The rubber stopper moves back too far on its adjustment
bolt. Adjust the bolt. The stopper spring needs to be more
tense. See procedure p. 13