14
Additionally, this unloading platform makes it possible to turn bales on one side or the other
according to the preference of the user. To make this change, the operator need only place the
barrier (6) on top of the platform, the foot (4), the support roller (1), and the retaining bar (5)
on the other side of the unloading platform. The same attachment points are situated on each
side of the platform to facilitate the change.
WARNING !
For transport, it is necessary to manually retract the retaining bar (2)
(
Erreur ! Source du renvoi introuvable.
).
With the unloading platform, it is possible to gently discharge bales on the cylindrical side
(without rotation). The operator need only raise the foot, remove the support roller (1), and
ensure that the 2 platform barriers are installed to limit movement.
Charging the accumulator
When
the unloading platform does not go back to its position, you must correct the pressure in
the accumulator to a pressure ranging from 1000 to 1200 lbs. A too low pressure will not lift
the unloading platform to its position and a too high pressure will not allow the bale to dump
from the unloading platform.
1.
Remove the handle (1)
2.
Turn the lock washer (2) to enable the handle to turn and open the ball valve (4).
3.
Replace the handle (1).
4.
Connect a hydraulic pump at the male quick connect (3).
5.
Open the ball vale (4). The unloading platform will go down.
6.
Put hydraulic oil to achieve a pressure of 1000 lbs. Press on the unloading platform
for to verify if he goes back to its position and adjust the pressure as required.
7.
Close the ball valve (4).
8.
Remove the handle (1).
9.
Turn the lock washer (2) that it’s lock the handle.
10.
Replace the handle (1).
Summary of Contents for 590HS
Page 1: ...404682 1 Round Bale Wrapper 590HS Operator s Manual 2021...
Page 2: ......
Page 26: ......
