Anderson 590HS, Operator'S Manual

Page: 13 / 94

11
4 Adjustment Procedures
Verifications Before Each Use
Check the level hydraulic oil in the tank of your unit. Check the oil level in the Honda engine, if
applicable, as well as the need for fuel. Open the fuel valve and check the engine air filter. If
necessary, lubricate the machine well after each day of use. Every day, check the cleanliness of
the plastic film stretcher rollers. Clean them as necessary with penetrating oil, rubbing alcohol,
or paint thinner.
At start-up, your bale wrapper must be placed in the most horizontal position possible. Detach
the turntable’s L-shaped latch (Figure 2.1). If you have the stabilizer option, start the machine
and pull the 2 levers of the control to put them in place If the film roll is in place, check if the
edge of the plastic is properly held by the clamp of the film cutter. If not, tighten the clamp
around the plastic film by pulling the lever
Installing the Plastic Film Roll
When the film roll is empty, remove the spool by pushing it upward to compress the retaining
spring of the upper support (Figure 4.1). Install the new roll in the same manner.
Figure 4.1 Installing the film roll