AND Check Weighing Indicator AD-4404, Instruction Manual

Page: 78 / 162

Page 76
9.2. 9.2. 9.2. 9.2. Built Built Built Built----in RS in RS in RS in RS----485 Interface 485 Interface 485 Interface 485 Interface
The RS-485 interface can use commands to control the indicator. The interface can
read weighing data or parameters and store parameters in the indicator.
The interface can connect 32 units maximum and a personal computer using a
communication cable.
Each unit is specified by an address appended to the command.
Specifications
Transmission system .........EIA RS-485, Asynchronous, bi-directional, half-duplex
Data length ........................7 bits or 8 bits
Start bit ..............................1 bit
Parity bit.............................Odd, Even, not used
Stop bits.............................1 bit, 2 bits
Baud rate ...........................600 bps, 1200 bps, 2400 bps, 4800 bps, 9600 bps, 19200
bps, (38400 bps for jet stream mode only)
Line....................................2 wires (2-balanced wires)
Connection ........................Max. 32 units
Character code ..................ASCII code
Terminator............................. CR, CR LF
Instructions for Use
When using a terminator, connect it to the SDA and SDB terminals using the
accessory resistor.
If there is no signal ground at the host computer, it is not necessary to use the SG
terminal.
If a shielded cable is used, connect the FG teminal to the shield line.
When connecting to the RS-232C, use a converter of an RS-232C/ RS-485 converter
avilable on a market.
Use a muitiple drop connection for command mode.
Do not use a multi-drop connection in stream mode or jet stream mode.
9.2.1. 9.2.1. 9.2.1. 9.2.1. Settings of Parameters for RS Settings of Parameters for RS Settings of Parameters for RS Settings of Parameters for RS----485 485 485 485
Refer to the "11. Parameter List" of the function list.
[Function] - [Set function] - [Serial] - [RS-485] - [
r5 f- 1
] to [
r5 f-13
]