Installations (refer to Page 4 for parts):
NOTE: Use threaded drywall anchors only when
mounting the hood on sheet rock. Mounting
the hood on wall studs or lumbars is highly
•
recommended with a minimum of 30" for gas stove tops.
•
•
•
•
•
•
•
•
•
•
•
recommended.
Step 1: Measuring
To reach 9ft ceiling make sure hood is installed at 30" from cooking surface
If you require longer chimney flue to reach your ceiling please contact vendor.
Step 2: Installing the hood mounting bracket
Determine and mark the center line on the ceiling where the range hood will be installed. Make sure
there is proper clearance within the ceiling or wall for exhaust vent
The ceiling must be able to bear at least 40 kg (88 lbs.) of weight, and the thickness of the ceiling must
be at least 30 mm (1.18 in.)
Drill 1*170 mm (6.7") round hole in the ceiling.
Run house electrical wires to the electrical box on the bracket.Black to Black, White to White, and
Green to Green or Bare wires.
In line with the hanging board, drill 12 holes in the ceiling. See fig. # 1
Using appropriate screws attach the hanging board to the ceiling
Use supplied screws and nuts with washer to attach the angle iron into the hanging board. See fig. #2
Calculate the total length of the angle iron required so that the overlap angle iron is no less than 100 mm
(39.4") and that the distance from the bottom of the range hood and the cooking surface is between 61 to
76 cm (24" to 30")
Attach the 2 sections of the angle iron together for each corner using provided flat screws and nuts.
Measure the distance between stove top and the bottom of range hood. A distance of 24" to 30" is
10
Fig # 1
Fig # 2
Model #
Aero Island 36
INSTALLATION:
Summary of Contents for Aero Island
