19
Install End Uprights: (See Bottom of Page 18) One worker stands on base of upright at ground
level, while second worker walks the top of the upright to vertical. Align the T-fitting at top of upright
with the slot of the upright bracket on the underside of the beam. Lift upright until T-fitting enters
slot, then rotate upright 90 degrees with offset to the inside (as shown). (Do not anchor the uprights
until after the eave bars have been installed.)
Install end and wing eave bars in the sequence shown above. For later ease of wall installation, be
sure the notch (for inserting wall hooks into bottom channel of eave bars) faces toward the inside of
the structure. If this is not done, wall can still be installed, but this alignment will make it easier.
Consult the Footprint Drawing supplied with your structure for correct positioning and anchor each
upright with (2) 24” stakes (or anchor bolts, depending upon the loading requirements of your instal-
lation). (NOTE: On 40’ and 50’ Spans, see Index Page “X-3” for necessary End Center Bars)
Install Baseplate
Adapter Bars
As Shown. These
are required for
either Gabled Ends
or Sloped Ends.
(If both ends are
installed on the same beam,
only one set of
adapter bars is needed)
Correct Sequence for Installing End Framing
Install Baseplate Adapter Bars
Note: 40’ & 50’ spans use end center
bars in place of center upright
At uprights, insert
round rivet head
into keyhole and
drop into slot
WING EAVE BAR
Drop hook end into
Wing Eave Bracket
END EAVE BAR
Keyholed slots
in uprights
VIEW IS FROM OUTSIDE
Drop Slots over baseplate tabs.
Insert bent arm pin into small key-
hole of baseplate.
Insert #10 hair pin cotter to
lock in place.
INSIDE OF STRUCTURE
