Analog Devices EZ-KIT Lite ADSP-BF707, System Manual

Page: 29 / 85

ADSP-BF707 EZ-KIT Lite Evaluation System Manual 1-11
Using ADSP-BF707 EZ-KIT Lite
For more information, refer to the CAN0 example in the POST, which is
included in the ADSP-BF707 Board Support Package.
CAN1 Interface
The Controller Area Network 1 (
CAN1
) interface of the EZ-KIT Lite is
connected to the NXP TJA1041 CAN transceiver (
U47
). The transceiver is
attached to the
CAN1
port of the ADSP-BF707 processor via an RJ-11 con-
nector (
J5
). See CAN1 Connector (J5) .
The
CAN1
transmit and receive signals are connected through the SoftCon-
fig switches and enabled by default.
CAN1_EN
is enabled by default.
CAN1_ERR_EN
(error) and
CAN1_STB
are disabled. See Software-Controlled
Switches (SoftConfig) .
For more information, refer to the CAN1 example in the POST, which is
included in the ADSP-BF707 Board Support Package.
USB Interface
The ADSP-BF707 processor has an integrated USB PHY; the EZ-KIT
Lite provides a micro AB connector. The board supports USB high speed
mode.
The board supplies a maximum of 5V at 500 mA to a peripheral device by
enabling the FET switch (
U40
). The USB controller controls the FET
switch through the
USB0_VBC
signal.
To learn about the processor’s device and host modes, refer to the USB
example in the POST, which is included in the ADSP-BF707 Board Sup-
port Package. For more information, refer to the hardware reference
manual.