UG-851
EVAL-AD7605-4SDZ/EVAL-AD7606SDZ/EVAL-AD7607SDZ/EVAL-AD7608SDZ User Guide
Rev. A | Page 10 of 15
WAVEFORM CAPTURE TAB
The Waveform tab, shown in Figure 13, is used for waveform
capture.
The waveform analysis reports the amplitudes recorded from
the captured signal as well as the fundamental frequency of the
signal tone. The analysis report is generated for the ADC
channel selected via the ADC 1 ON/ADC 1 OFF to ADC 8
ON/ADC 8 OFF buttons (Label 1 in Figure 13).
At the bottom right of the graph are the zoom options. These
allow the user to zoom in to look closer at a sample. The Waveform
Analysis section (Label 2 in Figure 13), which is located beneath
the waveform graph, contains information about the samples taken;
the peak-to-peak amplitude, the minimum/maximum amplitude,
the mean, the standard deviation of the captured data, and the
fundamental frequency of the signal tone are shown.
The waveform graph displays the information for all eight input
channels or as many channels as desired. Eight buttons located
to the right of the graph, labeled ADC 1 ON/ADC 1 OFF to
ADC 8 ON/ADC 8 OFF, selects which channel data displays
(Label 1 in Figure 13). An indicator, located to the right of the
graph (Label 3 in Figure 13), shows what color graph represents
each channel when the data from several channels is displayed.
Data Capture Display
Four tabs display the conversion data in different formats:
Waveform, Histogram, FFT, and Summary.
The tools shown in Figure 12 allow user control of the different
chart displays within the four tabs.
Figure 12. Chart Tools
Figure 13.
Waveform
Tab
13283-
013
1. USED FOR CONTROLLING
THE CURSOR IF PRESENT.
2. USED FOR ZOOMING IN AND OUT.
3. USED FOR PANNING.
1
2
3
1
3
2
13283-
014
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
