UG-1820
Rev. 0 | Page 4 of 24
EVAL-AD4115SDZ QUICK START GUIDE
RECOMMENDED QUICK START GUIDE
Use the following procedure to set up the EVAL-AD4115SDZ:
1.
Disconnect the
) board from the
USB port of the PC. Install the
See the Installing the AD411x Eval+ Software section.
Restart the PC after installation.
2.
Connect the
board to the EVAL-AD4115SDZ. Fasten
these two boards together with the enclosed plastic screw
washer set.
3.
Fasten the EVAL-AD4115SDZ and the
board together
with the enclosed plastic screw washer set.
4.
Connect the
board to the PC via the USB cable. For
Windows® XP, it may be necessary to search for the
drivers. Choose to automatically search for the drivers for
the
board if prompted by the operating system.
5.
Launch the
software from the
Analog
Devices
subfolder in the
Programs
menu.
QUICK START MEASUREMENT
Use the following procedure to capture data quickly:
1.
Connect the dc signal source to a selected voltage input (for
example, the VIN0 pin and VIN1 pin for differential input).
2.
Launch the
software and select
Quickstart
(see Figure 15).
3.
In the
Configuration
tab, under
Demo Modes
, click
All
Single-Ended
and then click
Sample
(see Figure 16).
4.
In the
Voltage Waveform
tab, the user can evaluate the
measured data.
The
Samples
box in the top right corner of the
window sets the number of samples collected in each batch.
