R e v 1 . 1
| Page
28
Transmitter Board Tx Packet Settings
Using the Tx/Rx packet tab you can set up the packet format and configure the packet handler. Ensure these settings
are the same as the Receiver settings previously set. (
Figure 35
point (
1
))
1.
The transmitted preamble length sync word and CRC can be defined by the user. (
Figure 35
point (
2
))
(Note: Ensure CRC is enabled for this test. You have the choice to use the default CRC or enable a
programmable CRC whose polynomial may be set in registers 0x11E and 0x11F.)
2.
Ensure you are using a fixed packet length and that, “
Packet Length Max
” is set equal the payload length.
(
Figure 35
point (
3
))
3.
Set up the Tx base address. (
Figure 35
point (
4
))
(Note : This is the start address of the Transmitted packet in Packet Ram Memory.)
4.
Insert Hex data in the
Payload Data
field (
Figure 35
point (
5
))
then click “
Write Payload to RAM
” (
Figure 35
point (
6
))
5.
Write the settings to the device using the “
Update Needed
” button. (
Figure 35
point (
7
))
Figure 35
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
