R e v 1 . 1
| Page
26
Receiver Board Interrupts
Interrupts may be configured for various conditions in the “
Interrupts”
tab. (
Figure 33
point (
1
))
1.
Set the “
crc_correct
”
interrupt. (
Figure 33
point (
2
))
This will give an interrupt signal upon reception of a packet with a valid CRC.
2.
Write the settings to the device using the “
Update Needed
” button. (
Figure 33
point (
3
))
3.
Put the part into Receive by pressing “
CMD_PHY_RX
” (
Figure 33
point (
4
))
(Note: Ensure that the current state of the part is in “
PHY_ON
” before pressing “
CMD_PHY_RX
”.)
“Board 1
” is now in Receive and waits for a transmitted signal. It will remain in Rx until a valid packet with a valid CRC is
received.
Figure 33
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
