R e v 1 . 1
| Page
11
Connecting the Evaluation Boards
This software can allow
TWO
evaluation boards to be connected to a single PC. The EVAL board and the software must
be setup accordingly.
Ensure that
Switch 4
is in the correct position before connecting to the PC as shown in
Figure 14
.
Figure 14
•
To set the first board as “
BOARD 1
” (
Figure 15
) on the Software set the switch shown in
Figure 14
to “
B1
”
•
To set the second board as “
BOARD 2
” (
Figure 15
) on the Software set the switch shown in
Figure 14
to “
B2
”
Ensure the evaluation mother board with the desired daughter card is connected to the PC via USB cable before running
the software.
Run the ADF7023 software from Start-> Programs->Analog Devices->ADF7xxx->ADF7023.
Once the software is running press Connect USB (
Figure 16
).
Figure 15
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
