AMX MAX-HT04, Operation/Reference Manual

Page: 49 / 56

Rack Mounting MAX Servers
43 MAX HT Servers
1.
Remove the four plastic plugs from each side of the MAX Server.
2.
Install the chassis sections onto the MAX Server chassis using 4 flat-head PHILLIPS screws
(included) per side, as shown in FIG. 42.
Step 2: Slide Intermediate Sections Into the Stationary Sections
1.
Slide the Intermediate Section into the Stationary Section, from the rear end of the Stationary
Section, as shown in FIG. 43.
2. Press the Locking Tab on the Stationary Section to allow the Intermediate Section to slide fully into
place.
3. Slide the Intermediate Section in, to the point that the Breaker tab on the Intermediate Section rests
against the Stopper on the top guide-rail on the Stationary Section, and the locking tab snaps into
place.
FIG. 42 Attaching the Chassis Sections to the server chassis
FIG. 43
Sliding the Intermediate Section into the Stationary Section
The Locking Tab on each Chassis Section should
be oriented towards the rear of the server
Chassis Sections
(front)
(rear)
HT Server chassis
(rear)
Breaker tab
Stopper
Locking tab
Locking tab hole
Breaker Post (on Intermediate Section)
Stopper (on Stationary Section’s top guide-rail)
(front)