Installation
13
MAX-AVP Audio-Video Player
a.
Place a flat washer on the mounting post, so that it rests against the inside surface of the chassis.
b.
Place a split lock-washer on top of the flat washer.
c.
Place a nut on top of the split-lock washer and secure.
Repeat these steps for the three remaining mounting posts.
7.
Repeat steps 5 and 6 to install the other rack-ear on the other side of the chassis (FIG. 7).
8.
Put the chassis sections back together and secure the two sections with the four screws removed
earlier.
9.
Remove the "feet" from the bottom of the unit. Each foot is secured to the chassis with a single
screw. Keep the feet and screws for further use.
Once the rack-ears have been installed, the AVP can be mounted into the equipment rack.
HDMI-to-DVI Conversion Cable (MDL200 Kit)
The MAX MDL200 Multi Disc Loader System comes as a kit that includes a PowerFile Multi-Disc
Loader, a Windows® PC pre-loaded with all required software and pre-configured for plug and play
operation, and a LCD monitor, keyboard and mouse.
The
HDMI-to-DVI conversion cable
allows you to connect the LCD monitor that comes with the
MDL200 kit directly to a MAX-AVP Audio-Video Player, to access the AVP’s Setup Pages.
Options in the AVP’s Setup pages allow you to complete initial configurations on the AVP, including:
Audio and video output settings
Fine tuning options (such as brightness, contrast and saturation)
Localization settings (including Region Code settings)
FIG. 7
Secure the rack-ears to the inside of the chassis
Secure the rack-ears to
the inside of the chassis
front
Refer to the MAX MDL200 Multi Disc Loader System Installation Guide and
Operation/Reference Guide (available online at www.amx.com) for detailed
instructions on using the MDL200 kit to bulk-load media to a MAX Server.
Refer to the Setup Page
section on page 46
for details on configuring the MAX-AVP.