Installation
4
Tango Zone Expanders
Front and Rear Panel Components
Cabling Instructions
This installation uses low voltage cabling similar to telephone and alarm wiring, and as such does not
commonly have very many restrictions on their installation. However rules may vary in different regions.
Cable Type
The Tango Amplifier is cabled using standard 4-conductor speaker cable originating at the Tango Controller,
passing through the Keypad, and terminating at the speaker location. AMX recommends using a bundled 4-
conductor 16-gauge stranded copper wire in a single continuous run.
FIG. 1
Tango Amplifiers (DAS-TAMP4-SIG shown)
Expansion Port IN: from Tango Audio Controller
Expansion Port OUT:
Address Switch
Zone Outputs (up to 8)
Paging IN/OUT
Stereo Inputs/Outputs (8)
Power Switch & Receptacle
to other Expander
or other Expander
(rear)
Be sure to check for any wiring restrictions required by the electrical code in your
area.
