![background image](http://html1.mh-extra.com/html/amx/control-cards-and-netmodules/control-cards-and-netmodules_instruction-manual_2938666011.webp)
NXF CardFrame and NetModules
5
NXF CardFrame, NetLinx Control Cards, and NetModules
3.
Place the AC-RK bracket (with the module) in the equipment rack and secure the bracket to the
rack.
4.
Replace the front faceplate on the module, and attach the translucent plastic cover to the
faceplate (if necessary).
Installing Control Cards into an NXF CardFrame
1.
Remove the magnetic front faceplate/viewing window from the CardFrame.
2.
Align the edge of the Control Card with a slot in the CardFrame. Slide the card into the
CardFrame and press until you feel the Card seat in the backplane connector.
3.
Put the magnetic faceplate back on the CardFrame. Secure with mounting screws (if
necessary).
Preparing/connecting captive wires
1.
Strip 0.25 inch of wire insulation off all wires.
2.
Insert each wire into the appropriate opening on the connector according to the wiring
diagrams and connector types described in this section.
3.
Tighten the screws to secure the wires in the connector. Do not tighten the screws excessively;
doing so may strip the threads and damage the connector.
Using the ID button
The ID Button on the rear panel of the NetModules (see FIG. 2) is used in conjunction with the
NetLinx Studio software program to allow you to assign new Device and System numbers for the
Module.
1.
Using NetLinx Studio, place the system in Identity (ID) Mode. ID Mode means the entire
system is put on hold while it waits for an event from any NetLinx device in the named system
(for example, pushing the ID button on a Module). The device generating the first event is the
identified device.
2.
Press the ID Mode button to generate an event from the Module and allow you to assign new
Device and System numbers in NetLinx Studio.
Summary of Contents for CONTROL CARDS AND NETMODULES
