![background image](http://html.mh-extra.com/html/amx/bcs/bcs_instruction-manual_2938897049.webp)
Appendix C – Programmer’s Interface for System Diagnostics
46
Instruction Manual – BCS Basic Control Structure Protocol
Verbosity Settings
The verbosity (
v
) settings (
v0
,
v1
,
v2
,
v3
) correspond to the level of detail that will be displayed,
with
v0
being the lowest level of detail and
v3
being the highest level.
Component Identity Settings
Detailed information for a single system component can be specified (if the system supports it) by using
its identity (
i
) number setting (
i1
through
i7
) in the following table. Minimal information for all
supported components can be specified by using the identity number
i0
.
Note:
For the number of components that individual products support, see “Appendix A – Product
Specific BCS Commands” on page 25.
Default Settings
At system boot, the ~
scrv0i1!
setting is displayed.
If the verbosity setting is omitted, the verbosity level will be the lowest (
v0
).
The component setting must be included; otherwise, entering any of the verbosity settings
alone will result in a display equivalent to
v0i0
.
If both settings are omitted during a query (
~scr!
), the information displayed will be at the lowest
verbosity level for all components (
v0i0
) (FIG. 2 on page 45).
Component
Identity Number
All Components
i0
Enclosure
i1
Storage Blocks
i2
Communication Interfaces
i3
Hardware / Boards
i4
VM Configuration
i5
Power System
i6
System Sensors
i7