AMX AXU-MSP16, Instruction Manual

Page: 14 / 24

10 Installation AXU-MSP Series and AXM-MSP32
c.
Turn the captive screws clockwise to secure the wires.
d.
Connect the AXlink connector to the panel.
4.
Locate the green AXlink LED on the rear side of the panel. If the green LED
flashes once per second, the panel is communicating properly with the AXCESS
system. If the LED is on and not flashing, disconnect the AXlink connector and
recheck all AXlink connections. Afterwards, reconnect the AXlink connector to
the panel and verify the LED is flashing once per second.
5.
Locate the slot on the front panel and gently remove the overlay from the
faceplate.
6.
Place the panel in the wall, wall box, podium, or rack, and align the screw holes
with the mounting holes on the panel.
7.
Fasten the panel to the wall, wall box, podium, or rack using the screws
supplied with the panel.
8.
Put the engraved overlay back on the panel's bezel or rack mount faceplate.
Caution
Do not over-torque the screws
on the wires. Doing so can
bend the seating pins and
damage the connector.