AMT Datasouth XL 300 SERIES, Maintenance Manual

Page: 51 / 117

4.4.1: Printhead
The printhead should be removed and cleaned approximately every 4-6 months depending
on usage. Deterioration of print quality between scheduled cleanings would indicate a need
for more frequent cleaning. To remove and clean the printhead proceed as follows:
1.
Remove top cover (see Paragraph 4.5.1).
2.
Remove printhead (see Paragraph 4.5.24).
3.
After removing the printhead and bracket assembly from the carriage, clean the
head using a small hard-bristle brush and isopropyl alcohol. Only the printhead
should be cleaned including the wire tips and jewel bearing. All ink and ribbon
fabric residue should be removed in this process. Do not attempt to clean inside the
printhead case or around the cylinder the printhead coils.
4.
Replace in reverse order.
4.5: CORRECTIVE MAINTENANCE
This section contains procedures for removing and replacing components of the printer.
These procedures are supported by figures and parts lists which will aid the technician in
identifying individual parts.
WARNING
The printer must be disconnected from the A.C. power supply before any corrective
maintenance procedure is performed.
4-3