- 3 -
Z5
DT
User’s Guide
2 Printer installation
2.1 Installation position
Flatly place the printer on the operation table, which must be waterproof, moistureproof and dustproof. The
maximal tilted angle should not exceed ±15° during installation.
2.2 Label roll installation
1)
Pull the cover open lever towards the front of the printer and turn the top cover upward to open it (see
figure 2.2-1);
2)
Pull the left and right paper holders apart and load the label roll, then pull the front of label roll out to spread
it in the print path, and push the label under the paper guide (see figure 2.2-2); turn the thumb wheel
properly in the direction shown in the figure to decrease the force on label roll (see figure 2.2-3);
3)
Ensure the label is installed in the path correctly, and close the top cover;
4)
If the diameter of label roll is very big, use the corresponding tool to remove the paper holder baffles, then
turn the baffles, and insert them into the center holes of the left and right paper holders along the guiding
slot (see figure 2.2-4);
Figure 2.2-1 open top cover
Figure 2.2-2 load paper roll
Figure 2.2-3 adjust thumb wheel
Figure 2.2-4 change the installation way of paper holder baffle
