- 10 -
Z5
DT
User’s Guide
3.3 Printer parameter settings
3.3.1
Button menu settings
When the printer is idle, enter the configuration status through long press of the button. The common
parameters of printer can be set and saved under configuration status. Parameters can be configured by the
cooperation of LCD and button.
The following describes the setting and saving of printer parameters by taking the serial port configuration for
example:
1)
Keep pressing the button until the green LED flashes under idle status. Then the LCD will display the menu
as shown in figure 3.3.1-1.
1.SETUP
2.SELFTEST
3.CALIBRATION
4.PAUSE
1.SETUP
Figure 3.3.1-1 menu
Note:
After entering the menu, the printer will exit the menu automatically if the menu is not operated in two minutes.
2)
Press the button for a short time to switch to “SETUP” option. Then press the button for a long time and
release it after the green LED flashes to select the option and enter configuration menu. Press the button
for a short time to switch the menu to “SERIAL COM” option as shown in figure 3.3.1-2 and then press the
button for a long time to enter the submenu.
7.LEFT POSITION
8.TIME SETUP
9.DATE SETUP
10.SERIAL COM
10.SERIAL COM
Figure 3.3.1-2 configuration menu
3)
Press the button for a short time to switch the submenu to “BAUDRATE” option as shown in figure 3.3.1-3.
1.BAUDRATE
2.DATA BIT
3.STOP BIT
4.PARITY
1.BAUDRATE
Figure 3.3.1-3 serial configuration menu
Press the button for a long time to enter baud rate configuration option as shown in figure 3.3.1-4. At this
time, what is displayed on the LCD is the parameter being used now. If you do not want to change the
parameter, press the button for a long time to exit the option; if you want to change the parameter, press
the button for a short time to modify it.
