L0086, Rev. D
AMS SENSIT II GLASS FRONT VRM VENDOR
2-2
sealed refrigerant system may void the warranty.
1. Never puncture or cut any component in the
refrigeration system.
2. Always use licensed service technicians to service the
refrigeration system.
3. Always wear hand and eye protection when servicing
the vendor.
2.2.6 Vendor Tipping
The empty weight of the vendor is approximately
750 pounds (340 kg). A falling vendor can cause serious
injury or death. Caution should always be taken to avoid
dropping or tipping a vendor.
1. Never rock or tip the vendor. It must be kept horizontal
for safe operation.
2. Never place the vendor in an inclined position, such as
on a ramp or with all the legs not on the same
horizontal surface.
3. Never place the vendor in a moving environment such
as on a ship without properly securing it in place.
4. Never place the vendor in a location where it may be
struck by a vehicle.
5. Never transport an unsecured vendor.
6. Never attempt to lift or move the vendor by hand.
Always use equipment with the proper load rating.
Note that the Specification weight listed is empty
weight.
2.2.7 Other Improper Conditions
Hazardous conditions can be created by improper
use or service of the vendor.
WARNING:
Do not use electrical appliances inside the
vendor unless recommended by AMS.
1. Always reinstall any parts removed during service to
their original locations.
2. Never make unauthorized modifications to any part of
the vendor.
3. Always replace components that are worn, broken, or
otherwise unfit for use.
4. Never use unauthorized parts, or use parts for anything
other than their intended application.
5.
2.3 TEST STANDARDS
AMS vending machines bearing the ETL mark have
been tested for compliance with one of the following
standards:
2.3.1 Standard for Refrigerated Vending Machines
(ANSI/UL 541, 6th Edition, 10/30/03) and the
Standard for Refrigeration Equipment (CAN/CSA
C22.2 No. 120, 3rd Edition.
2.3.2 Standard for Safety for Vending Machines (ANSI/UL
751 6th Edition, 10/3/03 and the Standard for Vending
Machines, Consumer and Commercial Products
(CAN/CSA C22.2 No. 128-95
Summary of Contents for 39-VRM
