Ampro MightyBoard 800, Quick Start Manual

Page: 7 / 26

Chapter 1 Setting Up the MightyBoard 800
MightyBoard 800 QuickStart Guide 3
Connecting Cable Assemblies
Connect the cable assemblies provided with the MightyBoard 800 QuickStart Kit to the listed
connectors on the MightyBoard 800. Skip any steps or cable(s) that do not apply to your situation.
DIMM Slot
(184-pin, DIMM1)
Floppy Drive
(34-pin, J4)
Secondary IDE
(40-pin, J13)
Primary IDE
(40-pin, J14)
Utility (16-pin, J18)
ATX Power In
(20-pin, J3)
Keyboard (J1A)
Mouse (J1B)
Serial 1 (J5)
Parallel (J7)
CRT (J9)
Ethernet 1 (J15A)
Ethernet 2 (J12A)
USB 2 & 3 (J15B/C)
USB 0 & 1 (J12B/C)
Audio In/out (J17A/B/C)
PCI Bus Slot (32-bit, J20)
Serial 3 & 4 (20-pin, J19)
CPU Fan (J2)
M
B
800Q
k
S
_03a
Figure 1-1. MightyBoard 800 Connector Locations
1) Connect Floppy Cable •
Connect the Floppy cable to J4 on the edge of the MightyBoard 800 as
shown in Figure 1-2. Refer also to Figures 1-1 and 1-4.
The Floppy interface uses the standard 34-pin floppy drive connector.
2) Connect Primary IDE
cable •
Connect the Primary IDE cable to J14 on the edge of the MightyBoard 800
as shown in Figure 1-2. Refer also to Figures 1-1 and 1-4.
This cable provides two IDE connectors (40-pin) for an IDE device, such
as an IDE hard disk drive (HDD) or IDE CD-ROM, etc.
• If you want more than two IDE devices, connect the Secondary IDE cable
to J13.
3) Connect the Utility
Cable assembly
• Connect the Utility cable to J18 on the edge of the MightyBoard 800 as
shown in Figure 1-3. Refer also to Figures 1-1 and 1-4.
The Utility cable, or its equivalent, is required for Power-Up and Reset of
the MightyBoard 800.
♦
Green Power-On switch uses Pins-6 & -8 of the Utility Connector (J18).
♦
Red Reset switch uses Pins-10 & -12 of the Utility Connector (J18).