Ampro MightyBoard 800, Quick Start Manual

Page: 15 / 26

MightyBoard 800 QuickStart Guide 11
Chapter 2 Installing MightyBoard 800 Options
The procedures in the first part of this chapter describe how to install or remove the MightyBoard 800
SBC (Single Board Computer) options onto or from the board, including the DDR DIMM and the
CompactFlash card. Brief instructions for accessing and using the MightyBoard 800 Doc & SW
(Documentation and Software) CD-ROM and a brief description for loading supported Operating
Systems is also provided at the end of this chapter.
Memory Installation
The MightyBoard 800 uses a single DDR DIMM slot available on the underside of the board. The
MightyBoard 800 supports up to PC2700 DDR 333 (166MHz), 184-pin, +2.5V, unregistered/unbuffered
non-ECC DDR RAM DIMM.
NOTE
Ampro recommends using PC2700 DDR 333 (166MHz, 6ns),
+2.5V, 184-pin, DDR RAM DIMM for maximum performance.
The MightyBoard will operate acceptably with a PC2100 DDR
266 (133MHz, 7.5ns) DIMM.
Tools Required
Use an anti-static service kit (or the equivalent) to remove or install the DDR DIMM. An anti-static
service kit should include a static-dissipating work surface, a chassis clip lead, and a wrist or ankle strap.
Installation Guidelines
•
When handling a DDR DIMM, observe anti-static discharge precautions to avoid damage.
•
The MightyBoard 800 uses up to PC2700 DDR 333 (166MHz) DDR RAM DIMM, which is
electrically different from single stroke SDR DIMMs.
•
The following DDR DIMMs sizes are available from Ampro: 128MB, 256MB, 512MB, or 1GB.
•
The MightyBoard 800 supports up to 1GB of memory in the DDR DIMM slot.
Removing the DDR DIMM
Use this procedure to remove the DDR DIMM from the DDR DIMM slot on the MightyBoard 800.
1. Prepare the MightyBoard 800 for DDR DIMM removal:
♦
If the MightyBoard 800 is already prepared for DDR DIMM removal, with the power turned
off, and the power cord disconnected, skip to Step 4.
♦
If the MightyBoard 800 is operating, power down the system and continue with next step.
CAUTION
To prevent damage to the MightyBoard 800 and the DDR DIMM, ensure
the power switch on the ATX power supply is turned off and the power
cord has been removed from the power source. The typical ATX power
supply will continue to provide standby current to the board until the
power cord is disconnected.
2. Disconnect the ATX power supply’s power cord from the power source.
3. Disconnect any cables that would prevent you from accessing the DDR DIMM slot on the
MightyBoard 800.