27
8. MAINTENANCE
8.1 STATE OF MAINTENANCE
The maintenance operations must be performed with the machine in the conditions described at the
paragraph “state of the machine” in the tables 8.6 and 8.7.
8.6 ORDINARY MAINTENANCE
The following operations must be executed on the times indicated here below. Not observing the
following instructions exonerate the Producer from any responsibility regarding the warranty.
The operations described here below, even if simple, must be executed by qualified personnel.
The scheduled ordinary maintenance includes overhauls, checks and interventions that, to prevent
stops and breakdowns, keep under systematic control:
•
Lubrication state of the machine
•
Wear and tear parts state
8.2 MACHINE ISOLATION
Before performing any type of maintenance or repair , it is necessary to isolate the machine from
the feeding sources, making the following operations:
1) Disconnect the plug from the electric socket.
2) Disconnect the fast clutch fitting from the pneumatic system.
8.3 SPECIAL CAUTIONS
During the maintenance or repair operations we suggested to proceed as follows:
-
Before starting any operation place a sign-board “machine under maintenance” in a well visible
p o s i t i o n
-
Do not use solvents or flammable materials
-
Do not step on the machine parts, because they have not been projected to sustain the weight
of persons.
-
Disconnect the power supply from the electric system & disconnect the air supply
-
Once all the operations are finished, restore and place properly the protections and shields
removed or opened
8.5 LUBRICATION
Fill your lubricator with oil, use CASTROL MAGNA GC 32 or equivalent oil. Do not use oil with heavy
cleaners in it.
Furthermore, we recommend you lubricate the driver blade every 200 working hours.
ATTENTION: Unsuitable lubricants may cause valve seal problems (seals may become too large) and
consequent Valve jamming.
If you use glue when joining frames, we suggest you lubricate the
driver blade daily.
8.4 CLEANING
The machine structure is simple and robust therefore the mechanical parts do not require any
special maintenance.
It is recommended that you follow the rules listed here below:
-
Regularly remove glue or other residues from the V-nail head and from the upper part of the
driver blade;
-
always keep the V-nails magazine clean
-
remove any residue from the V-nail guide “L” shaped support.
Do not use water to clean the machine, otherwise the metallic parts may oxidise.
Press the F6 button. This will position the driver head to the maintenance
p o s i t i o n .
Press the F5 button to test the driving of v-nails while in the maintenance
mode.
Before performing any cleaning intervention, the operator must disconnect
the electric and the pneumatic systems.
Summary of Contents for Mitre-Mite VN4 MemoryProgram
