www.amp-research.com
8/11
IM77132 rev 08.07.19
A M P R E S E A R C H P O W E R S T E P
T M
– J e e p W r a n g l e r J L
Prepare large tie-wraps for mounting Power
Step Controller. Loosely loop tie-wraps around
large bundle of wires behind battery in engine
compartment. Insert controller into tie-wrap
loops and cinch down securely. The tie-wraps
should cinch down into channels on controller
surface. Connect power leads from Controller,
Red to positive battery terminal and Black to
the vehicle body ground as shown.
Route the two Wire Harness
legs down over the wheel
wells toward Motor Linkages,
long leg across to the driver
side. Secure harness with tie
wraps.
Splice Power Step trigger wires into the Door Ajar wires with provided Posi-Tap
TM
splicers. The Power Step
trigger wires color coordinate with the factory Door Ajar wires. Follow the steps below to correctly splice
wires.
Insert
Tighten
Strip 3/8”
Insert and
Tighten
1
10
5
11
9
Summary of Contents for PowerStep 77132-01A
Page 12: ......
