9/10
www.amp-research.com
A M P R E S E A R C H P O W E R S T E P – F O R D F 1 5 0 S U P E R C R E W
IM2996 rev 11.27.06
Under passenger front kick panel locate bundle that
comes from the rear of the vehicle. Open the bundle and
locate the Black with White stripe wire and splice in
Single Diode Harness with the diode end toward the front
of the vehicle.
6
Diode
Connect purple trigger wire to Double Diode Harness.
Connect one open end of the harness to the red
connecting wire from the door and the other end to
the blue butt connector of
step 25.
7
Trigger
Wire
Secure all loose wires with tie wraps and/or electrical
tape.
Reinstall the fuse that was removed in step 15 and
check for proper functioning of the step. Check for
even stow position of board.
Slight adjustments to the upper mount can be made
to adjust stow positon. With the board extended,
loosen hex bolt as shown, adjust as needed, and
retighten hex bolt to 16 ft-lbs. The adjustments will be
made to either increase or decrease the gap between
the board and rocker panel when stowed.
decreases gap
increases gap
#
25
7
26
27
28
29
