8/10
www.amp-research.com
A M P R E S E A R C H P O W E R S T E P – F O R D F 1 5 0 S U P E R C R E W
IM2996 rev 11.27.06
Remove driver side step plate and kick panel. Of the
three connectors to the left of the parking brake pedal,
locate the top connector . Splice single diode harness
into Black with Yellow stripe wire, diode end away from
connector as shown in figure.
6
Diode
Locate harness bundle under driver sill plate, open
bundle and find Black with Light Blue stripe wire. Splice
into wire single diode harness with the diode end toward
the front of the vehicle.
6
front of vehicle
Diode
Connect Double Diode Harness to purple trigger wire
and extend each end to the blue butt connectors of
steps 19 and 20.
7
19
Extension
Wire if needed
20
Trigger Wire
On the Passenger side remove front door paneling
and locate wire bundle running out toward the door
latch as shown. Connect Single Diode Harness to
Black with Pink stripe wire with diode end heading
back toward the vehicle cabin.
6
6
Diode
Pass supplied red connecting wire from door to cabin
through the door hinge wire accordion. You may want
to use the supplied plastic tubing to help pass the wire
through.
20
Connect door end of red connecting wire to the blue
butt connector of step 22. Secure any loose wires
with tie wraps and/or electrical tape.
20
19
20
21
22
23
24
