Fit the knobs using a small flathead screwdriver (knob colour may vary from that shown).
[Tighten up the right hand screw first - otherwise the knob turns while you are tightening it].
The finished faceplate should look like this (knob colour may vary from that shown).
Insert the LED through the hole in the faceplate and solder the LED to the underside of the switches PCB
The longer if the two leads is closest to the corner bracket.
Summary of Contents for ez2254
Page 1: ...ez2254 Compressor Limiter Assembly manual Colourbook Issue 1b...
Page 57: ...Finished chassis assembly should look like this...
Page 73: ......
Page 74: ......