Fit the 4 angle brackets to the front and rear panels using
1 x flat washer and 1 x plain nut (provided).
At this stage just fit them “finger tight”.
Snap apart the 3 insulator pieces.
[Ensure that any excess material has been removed where the insulators were snapped apart - not like the photo !]
Remove the 2 (M3 x 10) screws / nyloc nuts which secure the IEC Mains inlet to the PCB.
Place the insulator onto the underside of the PCB
(so that the mains transformer screw is visible through the hole in the insulator).
Secure in place by re-fitting the 2 screws and nyloc nuts previously removed.
Attach the earth cable to the
captive stud on the rear panel
using 2 x M4 Shakeproof washers
and 2 x M4 plain nuts (provided).
Ensure the first M4 nut is very
tightly fastened before fitting the
second M4 nut tightly.
(This is the safety earth bond)
Chassis assembly
M4 Plain Nut
M4 Plain Nut
M4 Shakeproof Washer
M4 Shakeproof Washer
Summary of Contents for ez2254
Page 1: ...ez2254 Compressor Limiter Assembly manual Colourbook Issue 1b...
Page 57: ...Finished chassis assembly should look like this...
Page 73: ......
Page 74: ......