11
-
5
11.7.2 Rubber Flails:.
Row Spacing: Normally row spacing is set once from the factory and will not need to be changed
unless the customer changes crop spacing. To set spacing:
1.
Open defoliator top doors for access to flails.
2.
Determine the required flail position by measuring from the center of the machine.
3.
Mark the center positon required for each flail basket.
4.
Loosen the flail basket bolts clamping the rings onto the
drum.
5.
Slide the assemblies to the desired position on the drum.
6.
Retighten flail ring bolts securing the basket to the drum.
Flail Replacement:
1.
Open defoliator top doors for access to flails.
2.
Inspect all flails and determine which ones need to be
replaced.
3.
Remove flail rod mounting bolt.
4.
Remove flail rod.
5.
Replace missing or damaged flails using only genuine Amity parts. Refer to the parts manual for
the appropriate part numbers.
6.
Reinstall hinge rod threading on spacers and flails in the appropriate sequence.
7.
Tighten flail rod mounting bolt.
NOTE:
When replacing all the rubber flails, use a soap and water solution to lubricate flail mounting
hole making it easier to slide the new flails onto the flail rod.
NOTE:
Rubber flail drums on the Amity defoliators rotate at approximately 400 RPMs are not bal-
anced from the factory and do not require to be rebalanced when flails are replaced.
Figure 11
-
5: Rubber Flail
Summary of Contents for 3200
