Amity Technology 3200, Operating Manual

Page: 24 / 77

6 - 3
6.4 Turning Radius
Turning at the end of the field while pulling the defoliator requires a wide area. One way to accom-
modate the large turning radius is to plant headland rows. Amity recommends a minimum of 48
headland rows
(22” [56 cm] spacing) on each end of the field.
•
Defoliators equipped with a CV PTO driveshaft can remain under power while turning in the
headlands.
•
Defoliators equipped with a Standard PTO driveshaft need to disengage the PTO before turning
to prevent driveline damage.
IMPORTANT: Failure to provide a sufficient turning radius for the tractor and defoliator may lead to
damage of the driveshaft, row finder assembly, scalpers, and/or tractor tires.
6.5 Break - in Period
After an initial 4 hours of normal field operation, hand check all fasteners and components. Tighten
or adjust any components as required. Do not re
- torque gearbox hardware as they have been in-
stalled with thread lock compound. If any gearbox hardware is found loose it should be fully re-
moved threads cleaned and reinstalled with thread lock to the torque spec as listed in section 11.0
Lubrication and Maintenance.
6.6 Field Cleaning
The defoliator will build with mud at different rates during operation depending on soil conditions.
It is important to fully open all doors, check material build up, and clean the machine if required
every two hours or more often if the conditions demand.
IMPORTANT: If left unclean, mud may clog the machine and may cause damage or premature com-
ponent wear. Frequently clean the machine to avoid potential damage and premature wear.
6.7 Flail Tubes
Amity offers many flail styles in row widths ranging from 18 to 36 inches (45 to 90cm). Flails can be
set up with all rubber flails (00 series only), or with a steel front drum with rubber flails on drums #2
and #3. Steel flail tubes operate at 1000 rpm and are factory balanced. Rubber equiped flail tubes
operate at 400 rpm and do not require balancing due to the lower operating speed. Flails may be
specifically matched to each growers needs. Please see your local Amity dealer or refer to your parts
manual for different flail options available.