Amish Country Gazebos Wood Gazebo-in-a-Box, Assembly Instructions Manual, Page: 16 / 28

11
Step 11. Installing the optional electrical package
3.
Then drill a 7/16” hole, straight
out, completely through the center
of the post.
Note: If you ordered the optional screen package, make this mark on the screen retainer, and drill the
7/16” hole, straight out, completely through the center of the screen retainer and post.
Note: If you have the optional benches, and you want the electrical package to be on the same post
as a bench support, you will need to cut 17” off the bottom of the electrical package trim strip,
making sure you do not cut the wiring. Then drill a 7/16” hole, straight out, completely through the
center of the post, approximately 2” above the top side of the bench support.
4.
Also, drill a 7/16” hole, straight up, and completely through
the center of the rafter, where this post and rafter meet,
(on the inside of the gazebo).
5.
Then, run the wires of the electrical package trim strip
through these holes, (The long wire at the top goes through
the rafter and the short wire goes through the lower hole)
and attach the trim strip to the inside of the post (centered)
with (10) 2” screws, through the pre-drilled holes.
(electrical package instructions continued on next page)
12
Note: If you ordered the optional screen package, install the screens and retainer
strips before you install the electrical package.
Note:
If you ordered the optional benches, install them before the electrical package.
1. Choose the post on which to install the electrical package.
2. Measure 7 ½” up from the
bottom of the post (on the inside
of the gazebo) and make a mark.
The electrical package trim strip has approximately 2’ of wiring on the bottom end and approximately
9’ of wiring on the top end.
Note: (If you installed the optional screen package,
attach the electrical package trim strip to the screen
retainer).