14 Amico Corporation
To load the network configuration file, press and hold the Reset button and the Setup button at the same time for two
seconds; then let go of the Reset button while still holding down the Setup button, until the network configuration file
are uploaded to the Area Alarm.
If the configured information does not appear on the screen, repeat the steps above. If the problem persists, contact
Amico Corporation for further assistance.
• Once the information is visible on the LCD Alarm screen, leave the SD Card in the slot for approximately 1
minute in order for the information to be completely uploaded onto the alarm, and then proceed to remove
the card.
• Once the card has been removed, restart the LCD Alarm to ensure that the configured network setting have
been saved onto the LCD Alarm.
BUILD DATE: OCT 24 2014
BUILD VERSION: 1515
GATEWAY: 192.168.1.1
MASK: 255.255.255.0
IP ADDRESS: 192.168.1.100
Configuration Guide
