Amica PGX 6510, Instruction Manual

Page: 8 / 28

8
INSTALLATION
Replacement of burner nozzle: loosen the nozzle with a dedicated wrench (7). Fit the new nozzle,
suitable for the required gas type (see table above for reference).
After you have converted the cooktop to another gas type, make sure you have placed a label containing
that information on the appliance.
Valve adjustment
Valve adjustment should be done with the control knob set at Burner ON saving flame position.
Remove the knob, and adjust the flame with a tiny screwdriver (see fig. 7 below).
7
Checking the adjusted flame: heat the burner at full open position for 10 minutes. Then turn the knob into the saving
setting. The flame should not extinguish nor move to the nozzle. If it goes off or moves over to the nozzle, readjust
the valves.
Note.
It is up to the used to request converting the appliance to another gas type if so required by the local conditions
at a licensed gas fitter / service.
NOTE
The cooktops delivered by the supplier come with the burners which are suitable for burning the type of
gas which is quoted in the type plate and in the guarantee certificate. The type plate is fitted at the bottom
panel of the appliance. The following must be carried out if converting to another gas type is required:
l
nozzles must be replaced (see assembling table),
l
reduced valve flow rate must be adjusted.
Converting the unit to another gas type
Gas type
Nozzle diameter
Small Medium Large
2H G20/20mbar 0,72 2 x 0,97 1,15
3+ G30/28÷30/37mbar,
3B/P G30/37mbar
0,5 2 x 0,65 0,85
Adjustment of the reduced valve flow
Burners Flame
Converting the cooktop
from LPG to natural gas
Converting the cooktop
from natural gas to LPG
Regular burners
Full flame
Replace the burner nozzle
according to the guideli -
nes in table 1
Replace the burner nozzle
according to the guideli -
nes in table 1
Saving flame
Loosen the adjustment
spindle (see fig. 7) and
adjust the flame
Loosen the adjustment
spindle (see fig. 7) and
adjust the flame
EN